Station Inventory

Had a theft a while back and lost a lot of gear...
QTH:

Kenwood TS-590S - Main HF rig (6m - 160m) for digital modes, CW, SSB

Kenwood TS-2000 - Main VHF/UHF rig (70cm - 160m) for local repeaters and satellites 

Radio Shack HTX-242 - VHF rig used for APRS Igate
Yaesu FT-840 - Got it broken and fixed it up.

Radio Shack PRO-2050 Scanner - Obvious...

Yaesu MD-100a8x Mic - Obvious...

Shure 526T Mic - Obvious...

MFJ-949D Antenna tuner - used for getting a 50-Ohm match for my radios on various antennas

MFJ-259b Antenna Analyzer  - used to determine the characteristics of an antenna

SEC-1223 Switching Power Supply - Obvious...

Yaesu FP-1030A Linear Power Supply - Obvious...

Radio Shack 13.8VDC 15A Switching Power Supply - Obvious...

NCG-3000 - V/U Power and SWR meter

NCG-2050 - HF Power and SWR meter

Mobile:

Kenwood TM-D710a - Mobile V/U with built in APRS support that I use in my truck

Garmin Nuvi 350 - Used to provide location data to Kenwood

Argent Data G-Trans cable - Connects GPS to Kenwood for APRS location

QRO Go-Kit:

Yaesu FT-840 - Backup HF rig (10m-160m) that I use in my go-kit

Kenwood TM-V71a - Mobile V/U that I use in my go-kit

MFJ-969 Antenna tuner - extended matching abilities that I use in my go-kit
Stanley Contractor Chest with homebrew mounting frame and padding

QRP Go-Kit:

Yaesu FT-817ND - Just got this, fun little low powered (QRP) radio for hiking

Emtech ZM-2 tuner - built from a kit, used for getting a 50-Ohm match for my radio on various antennas

SignaLink USB - used to connect radios to a PC for digital modes

Venom 3200mAh LiPo battery - keep four charged and ready to go

Homebrew 3S LiFE battery - Built by the former owner of the FT-817ND, really nice!
7Ah Sealed Gel Cell Battery - Obvious...

133' doublet antenna - Obvious...
Asus 9904HA EeePC running XP with HRD/DM780 (native 12V so no power supply needed)
Swiss Gear Laptop Bag for the radio, SignaLink, and netbook.

QRPp Go-Kit

Small Wonders Labs Rockmite-40 - 750mW CW only radio that I built from a kit

QRPme Texas Topper 5w amp for the RM-40 that was also a kit

Homebrew 40m Half Wave End-Fed antenna (pdf warning)
Stanley Series 2000 toolbox with foam-rubber liner

Bench:

Heath 2762 Variable Regulated Power Supply

Samlex RPS1204 4-6A Power Supply

MFJ-945E Antenna tuner

Generic variable temp soldering station

Generic DMM

Generic Capacitor tester

Suction mount vise

"Helping hands" alligator clip vise

HSMM Mesh "Go-Package":
This all went to a local ARES group

Site 1: 
Cisco/Linksys WRT54G v2 running v1.0 firmware
Cisco 7961G-GE IP Phones running 8.5.4 SIP firmware
Cisco 7914 Extension Module (14 extension sidecar)
Cisco ATA 187 two line ATA
Grandstream HT-286 ATA
Raspberry Pi running Asterisk and Prosody

Site 2:
Cisco/Linksys WRT54GL v1.1 running v1.0 firmware
Cisco 7961G IP Phones running 8.5.4 SIP firmware
APC NetBotz 420 IP Camera and Environment Sensor
Rubbermaid Roughneck 3gl Container

Site 3:
Cisco/Linksys WRT54GL v1.1 running v1.0 firmware
Cisco 7961G IP Phones running 8.5.4 SIP firmware
APC NetBotz 420 IP Camera and Environment Sensor
Rubbermaid Roughneck 3gl Container

Site 4:
Cisco/Linksys WRT54GLS running v1.0 firmware
Cisco 7961G IP Phones running 8.5.4 SIP firmware
Rubbermaid Roughneck 3gl Container